• Slick Pipe(Joint)

    WP :

     10K/15K

    Material :

     Alloy steel

    Standard :

     NACE MR0175

    For more infos, please contact us by email.

    Product introduction:

    Slick Pipe(joint)/Sliding Pipe(joint) is located below the SSTT-subsea test tree and is designed specifically to allow a blowout preventer’s pipe ram to close and seal around the outside diameter. This seal is used to isolate the annulus from the marine riser.The slick joint is available ported with a single 1/3 inch or 1/4 inch port that is carried through from the subsea test tree, which allows the operator the ability to pump chemical or control fluids to a sub situated down hole. Dual check valves isolate porting from wellbore pressure.








    ?
    久久久久久久综合日本